JUKI MB-1800 series Instruction Manual page 14

(2) Registration of the pattern of the cycle stitching
1) To register the pattern, press item selection switch
LED located at
In this state, press again item selection switch
Press once more item selection switch
and display the pattern No. you desire to register at display section A 3 using
In this state, the pattern No. is recorded to P1. Press again item selection switch
" at display section A 3 and press
"
2) Press again item selection switch
No. you desire to register in the second place at display section A 3 using
" is displayed at display section A 3 when the item selection LED of the pattern No.
If "
the pattern is in the state of not being inputted. When the item selection switch
number and pattern No. are alternately displayed at display section A 3.
3) It is not possible to advance to the input of the next P2 unless pattern No. is inputted to P1.
Register the patterns after P3 by the same operation. It is possible to register up to PF maximumly.
When the registration of the pattern is completed, press item selection switch
return to the normal setting state. At this time, "
stitching has been selected.
In addition, for the sewing of cycle stitching, P1 to PF can be changed in the set ready state using
switches 2. In this state, when item selection switch
lights up and pattern No. is displayed at display section A 3.
No.
4) To delete the registered pattern, set the display of the pattern No. to "
(3) Sewing of button of stitch shapes other than the representative stitch shapes and
that of stitch shapes by ROM data created by PGM-20
Make the LED of
pattern No. 52. When the pattern of the external ROM is selected, all the LEDs which display the stitch
shape light up.
The shape data has been stored in the pattern Nos. 1 to 51 beforehand. However, if the same number
exists in the pattern Nos. of the external ROM, the shape of the external ROM is selected.
OPERATION OF THE SEWING MACHINE
6
1
2
4
7
" is displayed at display section A 3.
. "
4 to light up the LED of pattern No.
light up with stitch shape selection switch
4 for two seconds to flash the item selection
4 and " " will be displayed at display section A 3.
4 to light up the item selection LED of the pattern No.
switch 8, then display will be changed to "
" is displayed at display section A 3 and the cycle
4 is pressed, the item selection LED of pattern
1 and select the stitch shapes after
5
8
3
switches 2.
/
4 to display
".
and display the pattern
switches 2.
/
lights up,
4 is pressed, P
4 for two seconds to
".
/