JUKI AMB-289/IP-420 Instruction Manual page 5

2. SETTING PROCEDURE OF SEWING PRODUCT
<In case of sewing flat/wrapped-around button with blindstitch or sewing flat button with blindstitch>
3
5
7
<In case of sewing flat button directly to cloth>
3
4
6
<In case of counter/stay button>
2
1
3
8
2
1
6
4
2
1
5
4
5
6 7
Set button 1 to button loader 2 and depress the back part of
the pedal to insert the button into button chucks 3 . (When the
button loader is not used, insert the button by hand since the
chuck is opened by depressing the back part of the pedal.)
Set cloth 4 to tongue 5 and make it come in contact with
tongue stopper 6 . (Release of the tongue is performed by de-
pressing the back part of the pedal.)
When the front part of the pedal is depressed, the button chuck
comes down to the sewing position where the sewing is pos-
sible.
* By setting the pedal motion mode of memory switch data
, the button chuck automatically comes down to the sew-
ing position.
→ For the details of the memory switch data,
"33. (2) Memory switch data list"
refer to
of INSTRUCTION MANUAL.
Sewing starts when start switch 7 is turned ON.
Set button 1 to button loader 2 and depress the back part of the
pedal to insert the button into button chucks 3 . (When the button
loader is not used, insert the button by hand since the chuck is
opened by depressing the back part of the pedal.)
Set cloth 4 under the needle, make the tongue come in contact
with the tongue stopper, and make cloth presser 5 come down by
depressing the front part of the pedal to fix the cloth. (By depress-
ing the pedal reversely, the cloth presser is released.)
When depressing the front part of the pedal again, the button chuck
comes down to the sewing position where the sewing is possible.
* By setting the pedal motion mode of memory switch data
the button chuck automatically comes down to the sewing position.
→ For the details of the memory switch data,
"33. (2) Memory switch data list"
refer to
INSTRUCTION MANUAL.
Sewing starts when start switch 6 is turned ON.
Set upper button 1 to button loader 2 and depress the back part
of the pedal to insert the button into button chucks 3 . (When the
button loader is not used, insert the button by hand since the chuck is
opened by depressing the back part of the pedal.)
Insert lower button 4 into button setting section 5 of the feed plate.
Set cloth 6 under the needle, make the tongue come in contact
with the tongue stopper, and make cloth presser 7 come down by
depressing the front part of the pedal to fix the cloth. (By depressing
the pedal reversely, the cloth presser is released.)
When the front part of the pedal is depressed, the button chuck
comes down to the sewing position where the sewing is possible.
* By setting the pedal motion mode of memory switch data
the button chuck automatically comes down to the sewing position.
→ For the details of the memory switch data,
"33. (2) Memory switch data list"
refer to
INSTRUCTION MANUAL.
Sewing starts when start switch 8 is turned ON.
–  –
↓
↓
in Operation section
↓
↓
↓
in Operation section of
↓
↓
↓
↓
in Operation section of
↓
,
,