Step # 1: Main Frame Assembly - ProSpot Fitness P-100 Owner's Manual

lnstructions for Assembly of the PROSPOTy'tnessrM P-100
Before assembly, choose a safe location for your PROSPOffttuessrM P-100. The PROSPOTlrzessrM P-100
has a footprint of approximately 6'x 6'. The barbell is approximately 7' long. Locate your PROSPOTltrressrM
P-100 away from any source of water. Do not allow any liquid lo be near the machine or spilled on any
electrical part. Do not insert any object into the electrical box.
Approximate assembly time is 1/2 hours.
A flat area of 8' x 8' will be required to assemble and properly use the PROSPOTIT/gssIM
P-100.
You will need the following tools and a helper to complete the assembly:
.
5 mm Allen Wrench
r
14 mm Box End Wrench
o
17 mm Box End Wrench
.
19 mm Box End Wrench
Floor Padding, such as cardboard, to avoid scratching your floor during assembly.
A good pair of scissors will be helpful jn separating the parts from one another while removing them from the
cartons.
HAND TIGHTEN all bolts. DO NOT fully tighten bolts until instructed to do so.
Before assembly, separate and identify the rightsided parts from the left-sided parts. These parts are easily
distinguished by the manner in which the pre-drilled holes align with corresponding parts, or are identified by
" L " & " R " s t i c k e r s .
The PROSPOTlrressrM P-100 uses several different lengths of bolts. Be careful to use the correct length of
bolt called for at each step of assembly. Refer to the sizing charts provided.
. WARNfNG: Never perform any maintenance on the PROSPOTfitnessrM
P-
100 while the Power Supply is plugged into the wall !!!
STEP # 1: MAIN FRAME ASSEMBLY
1 . Place the two Base Rails (1 & 2) opposite each other in the center of the assembly area as shown in the
lllustration. Place the Lower Cross Brace (3) between the two Base Rails (1 & 2) so that the side pre-drilled
holes of the Base Rails ('1, 2) align with the end holes of the Lower Cross Brace (3).
Carefully thread the Base Rail Wire Harness (8) through the corresponding big end holes of the Lower Cross
Brace (3) then pull the Wire Harness (8) out of the back big holes of the Lower Cross Brace (3).
Attach the two Base Rails (1 & 2) to the Lower Cross Brace (3) using two Cross Brace Backing Plates (13),
four bolts (28), eight washers (18) and four nuts (20) as shown. HAND TIGHTEN the bolts at this time.
Attach the Right Upright Guidepost Assembly (7, 10, 53) and the two Upright Support Plates (6) to the Right
Base Rail (1) using four bolts (28), eight washers (18) and four nuts (20) as shown. HAND TIGHTEN the
bolts at this time. (Note: The long end of the Upright Support Plate (6) should point to the rear of the
machine as shown in the illustration).
Attach the Left Upright Guidepost Assembly (9, 12, 53) and the two Upright Support Plates (6) to the Left
Base Rail (2) using four bolts (28), eight washers (18) and four nuts (20) as shown. HAND TIGHTEN the
bolts at this time. (Note: The long end of the Upright Support Plate (6) should point to the rear of the
machine as shown in the illustrationl.
2 .
3 .
5 .
I