Advertisement
lnstructions for Assembly of the PROSPOTItnessrM
PC-1000
.
Before assembly, choose a safe location for your PROSPOFJitnessrM PC-1000. The PROSPOTlrressrM PC-
'1000 has a footprint of approximately 6'x 6'. The barbell is approximately 7' long. Locate your
PROSPOTlrressrM PC-'|000 away from any source of water. Do not allow any liquid to be near the machine
or spilled on any electrical part. Do not insert any object into the electrical box.
.
Approximate assembly time is 1/2 hours.
o
A flat area of 8' x 8'will be required to assemble and properly use the PROSPOTlrtersrM PC-1000.
.
You will need the following tools and a helper to complete the assembly:
.
5 mm Allen Wrench
.
14 mm Box End Wrench
.
17 mm Box End Wrench
.
19 mm Box End Wrench
.
Floor Padding, such as cardboard, to avoid scratching your floor during assembly.
.
A good pair of scissors will be helpful in separating the parts from one another while removing them from the
caTtons.
o
HAND TIGHTEN all bolts. DO NOT fully tighten bolts until instructed to do so.
.
Before assembly, separate and identify the righfsided parts from the left-sided parts. These parts are easily
distinguished by the manner in which the pre-drilled holes align with corresponding parts. or are identified by
" L " & " R " s t i c k e r s .
.
The PROSPO"ffitnessrM PC-1000 uses several different lengths of bolts. Be careful to use the correct length
of bolt called for at each step of assembly. Refer to the sizing charts provided.
r WARNING: Never perform any maintenance on the PROSPOT/itnesslM
PC-l000 while the Power Supply is plugged into the wall !!!
STEP # 1: MAIN FRAME ASSEMBLY
1. Place the two Base Rails (1 & 2) opposite each other in the center of the assembly area as shown in the
lllustration. Place the Lower Cross Brace (3) between the two Base Rails (1 & 2) so that the side pre-drilled
holes of the Base Rails (1 & 2) align with the end holes of the Lower Cross Brace (3).
2. Carefully thread the Cross Brace Wire Harness (8) through the corresponding side pre-drilled holes of the
Base Rails (1 & 2) then pull the Wire Harness (8) out of the top holes of the Base Rails ('l & 2).
3. Attach the two Base Rails (1 & 2) to the Lower Cross Brace (3) using two Upright Support Plates (6), four
bolts (22), eight washers (18) and four nuts (20) as shown. HAND TIGHTEN the bolts at this time.
4. Attach the Right Upright Guidepost Assembly (7, 10,23\ to the Lower Cross Brace (3) and the Upright
Support Plate (6) attached on the right base rail (1) using two bolts (22), four washers ( 18) and two nuts (20)
as shown. HAND TIGHTEN the bolts at this time.
5. Attach the Left Upright Guidepost Assembly (9, 12,23) to the Lower Cross Brace (3) and the Upright
Support Plate (6) attached on the left base rail (2) using two bolts (22), four washers ( 18) and two nuts (20)
as shown. HAND TIGHTEN the bolts at this time.
6. Plug together both of the Cross Rail Wire Harness (8) to lower ends of the Spiral Signal Cables (46) Iocated
just under the perforated Slider Shields on back of the Screen Panels (23).
_ _ 1 _ _
Advertisement
