Table of Contents
Advertisement
(6) Power on
1) Set Power button on the front panel to [ON].
2) Make sure that that PWR LED lamp on the front panel is on.
(7) Unit test
1) Since this device executes a self-check immediately after power is turned on, make
sure that the RDY LED on the front of the panel does not light after power is turned
on.
2) The LEDs light if the self-check detects an unusual condition.
(8) System test
1) Software installation
Install appropriate software following IP-900E/IP-900D series Software User's Guide.
2) Set-up check
Various devices settings complying with the system specification are made from the
control terminal either directly or via the network.
3) Input video check
Make sure that the video input to the device is correctly output to the monitor
(television).
4) Data communication check
Make sure that the line used by the system is connected.
5) Status check
After the final setup, when the equipment is in the system operation state, make sure
that the device status LED (RDY) on the front of the device lights in green, and that the
alarm LED (ALM) is off.
79
Appendix
IP-900E/IP-900D series
Advertisement
Table of Contents
