POSIFLEX KS-6615 User Manual

POSIFLEX KS-6615 User Manual

Fan free touch terminal w/ slim or super slim base
Hide thumbs Also See for KS-6615:

Advertisement

KS- 6615 / 7315 / 6617 / 7317
Fan Free Touch Terminal
w/ Slim or Super Slim Base
User's Manual
Rev.: A0
FCC Notes:
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions manual, may cause interference
to radio communications. It has been tested and found to comply with limits for a Class
A digital device pursuant to subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against interference when operated in a commercial
environment. Operation of this equipment in a residential area is likely to cause
interference in which case the user at his own expense will be required to take whatever
measures to correct the interference.
Warranty Limits:
Warranty terminates automatically when any person other than the authorized
technicians opens the machine. The user should consult his/her dealer for the problem
happened. Warranty voids if the user does not follow the instructions in application of
this merchandise. The manufacturer is by no means responsible for any damage or
hazard caused by improper application.
About This Manual:
Posiflex has made every effort for the accuracy of the content in this manual. However,
Posiflex will assume no liability for any technical inaccuracies or editorial or other
errors or omissions contained herein, nor for direct, indirect, incidental, consequential
or otherwise damages, including without limitation loss of data or profits, resulting
from the furnishing, performance, or use of this material.
This information is provided "as is" and Posiflex Technologies, Inc. expressly
disclaims any warranties, expressed, implied or statutory, including without limitation
implied warranties of merchantability or fitness for particular purpose, good title and
against infringement.
The information in this manual contains only essential hardware concerns for general
user and is subject to change without notice. Posiflex reserves the right to alter product
designs, layouts or drivers without notification. The system integrator shall provide
applicative notices and arrangement for special options utilizing this product. The user
may find the most up to date information of the hardware from web sites:
http://www.posiflex.com or http://www.posiflex.com.tw or http://www.posiflexusa.com
All data should be backed-up prior to the installation of any drive unit or storage
peripheral. Posiflex will not be responsible for any loss of data resulting from the use,
disuse or misuse of this or any other Posiflex product.
All rights are strictly reserved. No part of this documentation may be reproduced,
stored in a retrieval system, or transmitted in any form or by any means, electronic,
mechanical, photocopying, or otherwise, without prior express written consent from
Posiflex Technologies, Inc. the publisher of this documentation.
© Copyright Posiflex Technologies, Inc. 2008
All brand and product names and trademarks are the property of their respective holders.
Part 1
P/N: 16560900020

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KS-6615 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for POSIFLEX KS-6615

  • Page 1 KS- 6615 / 7315 / 6617 / 7317 Fan Free Touch Terminal w/ Slim or Super Slim Base User’s Manual Rev.: A0 FCC Notes: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions manual, may cause interference to radio communications.
  • Page 2 ALERT TO OUR HONORABLE CUSTOMERS: Please always read thoroughly all the instructions and documents delivered with the product before you do anything about it. Don’t take any premature action before you have a full understanding of the consequences. This product contains inside a Lithium battery and maybe also a sealed type Lead acid battery if the UPS battery option is ordered.
  • Page 3: Product Pictures

    INTRODUCTION PRODUCT PICTURES Front Views w/ Gen 5 base w/ Gen 6 base w/ Gen 5 base w/ Gen 6 base Side Views w/ Gen 5 base w/ Gen 5 base w/ Gen 6 base w/ Gen 5 base w/ Gen 6 base Inside the touch open cover Rear Views w/ Gen 5 base...
  • Page 4: Parts Identification

    Bottom Views Gen 5 base Gen 6 base PARTS IDENTIFICATION 1. Main unit 16. Optional top mount upgrade kit 2. Optional base mount kit e.g. e.g. PD-310 or PD-2604 PD-306 for Gen 5 Slim base 17. Power switch model 18. Brightness adjust push button 3.
  • Page 5: Product Features

    WinXP Pro, WEPOS and Windows Vista for KS-7315/7317 (Vista 64 bit for Core 2 Duo CPU model only) High quality 15” TFT active matrix LCD panel for KS-6615 / 7315. High quality 17” TFT active matrix LCD panel for KS-6617 / 7317...
  • Page 6 Touch control functions: left/right button, double click, drag & draw Dual display support (per OS capability) Dynamic video memory (max. 128 MB for KS-6615 / KS-6617, max. 224 MB for KS-7315 / KS-7317) Support high performance DDR2 DRAM with maximum memory size...
  • Page 7: Opening Cable Cover

    INSTALLATION GUIDES CAUTION: Before any installation or cable connection to the set, please always make certain that the system is turned off and the external power source to the set is removed to prevent electric hazard! Never touch any metal pin in the connectors or circuits to avoid high voltage hazard or electrostatic discharge damage unless the operator is well grounded.
  • Page 8: Separating Main Unit

    when disconnecting any connector. Failure to do this could damage the cable and jack that is considered as an artificial destruction. Damages due to incorrect disconnection operation are not covered by product warranty! SEPARATING MAIN UNIT In order to settle the touch terminal properly in a point of sale system, all the cable connections have to be routed through its base.
  • Page 9 battery cable. The UPS battery will be held in place when the bottom plate is screwed back. As for gen 6 super slim base model, please remove the UPS battery bracket on bottom of the stand assembly instead of the bottom plate as in the right picture. Please pay particular attention to the environment requirements for UPS battery in next Gen 6 base...
  • Page 10: Preparing The Main Unit

    ROUTING THE CABLES Gen 5 base Gen 5 base Gen 5 base The designed cable routing for all external cable connections referring to the pictures above is to have all the cables coming from outside into the cable exit (position A) at bottom side of gen 5 slim base and to be regulated into the two cable holders (B) then enter the base through the passage (C).
  • Page 11 window are designated for VGA port and COM port power supply function. Please consult your dealer for technical support on setup of these jumpers. Please note that only those qualified technicians Jumpers adjust service window with information from Posiflex and the contents in the Service Window service window may change Lock Screw...
  • Page 12: Desktop Mounting

    the DC supply in COM port is not required, it will be powered through the USB port. CONNECTING CASH DRAWER (OPTION) The RJ11 connector in main connection area of a KS system can be used for controlling most of the common cash drawers available on the market. However, it is most recommended that the Posiflex CR-2000 or CR-2200 or CR-3100 or CR-3200 or CR-4000 or CR-4100 or CR-4210 or CR-6210 be used for best compliance.
  • Page 13: Wall Mounting

    For desk top/counter application, the body of KS-6615/7315 occupies a space of 378 mm wide, 304 to 321 mm deep and 294 to 362 mm high per main unit tilt angle.
  • Page 14: Connecting Cables

    15”85.1/89.4T 17”89 8/94 1T dimensions and is 378 mm in width and 312 mm in height for KS-6615/7315 and is 426 mm in width and 370 mm in height for KS-6617/7317. CONNECTING CABLES To have the re-assembled main unit with stand assembly ready for operation, please connect all required cables to the appropriate connectors.
  • Page 15: Operating System Installation

    For KS systems preloaded with Windows XP Pro or WEPOS on HDD, Posiflex provides recovery CD or DVD delivered with the touch terminal for the preloaded operating system. The System Integrator shall take care of software restoration after OS recovered. A Posiflex supplied USB interface CDROM drive will be required for such action.
  • Page 16 be powered off for more than few days, please always disconnect the battery from the system. Reconnect it and turn on the system to recharge the battery for 1 ~ 2 hours every 3 months for temperature lower than 30C. Recharge for 1 ~ 2 hours every month for temperature over 30C.
  • Page 17 POWER ON/OFF & BRIGHTNESS CONTROL Touch Open Cover A gentle tap on the touch w/ Gen 5 base w/ Gen 6 base open cover at left side of the main unit will open the cover and show the power switch, brightness adjust push button switches and a double deck USB connector.
  • Page 18: Customer Display

    this forced power off, please disconnect the UPS battery if installed and the AC power supply for few minutes. This may reset all hardware registers. This switch can also be programmed as an ON only switch. That means, if the application program issues a command compliant with the KS series technical manual, this switch will always turn the system on when activated, but will not power off the system when pushed again (the forced power off feature will not work in this mode).
  • Page 19: Display Issues

    Main LCD Display For best viewing result please set your display resolution at 1024 x 768 with high color for KS-6615/7315 and set it at 1280 x 1024 with high color for KS-6617/7317. The system supports Dynamic Video Memory Technology. To allow Advanced Chipset Features the OS to utilize this feature, please select “Advance Chipset Features”...
  • Page 20 Mouse Emulation The touch panel in KS system uses USB interface as standard. Only the optional InfraRed type touch panel model uses RS232 interface. When the touch driver is properly installed, this touch panel works exactly like a standard mouse for both interfaces. However, if the system is running under safe mode, most drivers are disabled in this mode and the touch panel calibration is therefore not guaranteed.

This manual is also suitable for:

Ks-6617Ks-7317Ks-7315

Table of Contents