Connecting Using The S-Video Output; Connecting Using The Component Video - Pioneer S-HTD340 Operating Instructions Manual

02 Connecting up
• Placing the system unit too close to your TV
may cause interference, especially if you're
using an indoor antenna. If you notice
interference, move the system unit away
from the TV.

Connecting using the S-video output

If your TV has an S-video input, you can use this
instead of the standard video output for a
better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video
input on your TV.
Line up the small triangle below the jack with
the same mark on the plug before plugging in.
TV
P
R
COMPONENT
VIDEO OUT
P
B
• The S-video output is switchable between
S1 and S2 formats for compatibility with all
TVs. See Video Output settings on page 63
for more on this.
14
En
S-VIDEO
INPUT
VIDEO
IN
OUT
CONTROL
S-VIDEO
OUT
Y
VIDEO
SPEAKERS
FRONT
SUB
CENTER
WOOFER
R L
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV. This should
give you the best quality picture from the three
types of video output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT to a set of component inputs
on your TV.
TV
VIDEO
OUT
P
R
COMPONENT
VIDEO OUT
P Y
B
• The component video output is switchable
between interlaced and progressive
formats. See Video Output settings on
page 63 and Watching progressive scan
video from the component video outputs
below for more on this.
COMPONENT
INPUT
IN
CONTROL
S-VIDEO
OUT
VIDEO
SPEAKERS
FRONT
SUB
WOOFER
R L