Placing The Speakers - Pioneer S-HTD340 Operating Instructions Manual

Connecting up
• These speaker terminals can be under
HAZARDOUS VOLTAGE. When you
connect or disconnect the speaker cables,
to prevent the risk of electric shock, do not
touch uninsulated parts before
disconnecting the power cord.
• Do not connect any of the supplied
speakers to any other amplifier. This may
result in malfunction or fire.
This system has been designed for best
performance when connected to the
supplied speakers. We do not, therefore,
recommend that you connect and use
other speakers with this system.
1 Twist and pull off the protective shields
on each wire.
2 Connect to the speaker terminals on the
rear of the system unit.
Match the colored wire with the color-coded
label (above the tabs), then insert the colored
wire into the red (+) tab and the other wire with
the black (–) tab.
3 Connect to the speaker terminals on the
rear of the speakers in the same way.
• Remove the supplied non-skid pads from
the paper, and stick four onto the base of
each satellite speaker. Actual speakers
supplied may differ from those shown.

Placing the speakers

Depending on the size and characteristics of
your room, you can choose to place your
speakers in one of two ways using this system:
• Standard surround 5-spot setup – This is
a standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theatre sound.
System
Front left
unit
Surround
left
Sub-
Front right
woofer
Center
Surround
right
02
11
En