Table of Contents
Advertisement
12
Additional information
This system is designed for use with
conventional, fully circular discs only. Use of
shaped discs is not recommended for this
product. Pioneer disclaims all liability arising
in connection with the use of shaped discs.
Proper installation and
maintenance of this system
Hints on installation
We want you to enjoy using this system for
years to come, so please bear in mind the
following points when choosing a suitable
location for it:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such as
a table, shelf or stereo rack.
Don't...
Use in a place exposed to high
temperatures or humidity, including near
radiators and other heat-generating
appliances.
Place on a window sill or other place where
the system will be exposed to direct
sunlight.
Use in an excessively dusty or damp
environment.
Place directly on top of an amplifier, or
other component in your stereo system
that becomes hot in use.
Use near a television or monitor as you may
experience interference—especially if the
television uses an indoor antenna.
Use in a kitchen or other room where the
system may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover with
cloth—this may prevent proper cooling of
the system unit.
70
En
Place on an unstable surface, or one that is
not large enough to support all four of the
system unit's feet.
Cleaning the pickup lens
The DVD player's lens should not become dirty
in normal use, but if for some reason it should
malfunction due to dust or dirt, consult your
nearest Pioneer authorized service center.
Although lens cleaners are commercially
available, we do not recommend using them
since some may damage the lens.
Problems with condensation
Condensation may form inside the system unit
if it is brought into a warm room from outside,
or if the temperature of the room rises quickly.
Although the condensation won't damage the
system, it may temporarily impair its
performance. For this reason you should leave
it to adjust to the warmer temperature for
about an hour before switching on and using.
Moving the system unit
If you need to move the main unit, first remove
all discs, then press
front panel to turn the system off. Wait for
Good Bye to disappear from the display, then
unplug the power cord. Never lift or move the
system during playback—discs rotate at a high
speed and may be damaged.
• Unplugging the system before Good Bye
disappears from the display may cause the
system to return to the factory settings.
Power cord caution
Handle the power cord by the plug part. Do not
pull out the plug by tugging the cord, and never
touch the power cord when your hands are
wet, as this could cause a short circuit or
STANDBY/ON on the
Hide quick links:
Advertisement
Table of Contents
