Other connections
1
Press SOUND .
2
Use
to select 'RecMode?' then press
ENTER .
3
Use
to select 'RMode On' or
'RModeOff' then press ENTER to confirm.
• RMode On – A surround-compatible
downmix (left-total/right-total, or Lt/Rt) of
Dolby multichannel sources is output,
(suitable for Dolby Surround Pro Logic or
other matrix decoding).
• RMode Off – A simple stereo downmix
(left-only/right-only, or Lo/Ro) is output
(suitable for playback on a two-channel
stereo system or on headphones).
Connecting external antennas
For an external AM antenna, use 5–6 meters of
vinyl-insulated wire and set up either indoors or
outdoors. Leave the loop antenna connected.
Outdoor antenna
Indoor
antenna
(vinyl-coated
wire)
For an external FM antenna, Use a PAL
connector to hook up an external FM antenna.
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 26.
AM
LOOP ANTENNA
5–6m
PAL connector
Connecting the S-video output
If your TV has an S-video input, you can use this
instead of the standard video output for a
better quality picture.
•
Use an S-video cable to connect the S-
VIDEO OUT to an S-video input on your TV.
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
TV
OPTICAL IN
IN
AUDIO
CONTROL
LINE 2
FM
ANTENNA
UNBAL 75Ω
COMPONENT
VIDEO OUT
Y
P
B
P
VIDEO
R
S-VIDEO
OUT
OUT
VIDEO
XV-DV535
Connecting using the
component video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV.
give you the best quality picture from the three
types of video output available.
08
S-VIDEO
INPUT
AM
LOOP ANTENNA
1
This should
31
En