Changing Discs - Pioneer S-HTD340 Operating Instructions Manual

04 Getting started
For DVD discs only: If you change discs using
the DISC SKIP, DISC or DIRECT PLAY buttons,
or take the disc out of the player, the play posi-
tion is stored in memory. When you load the
disc next time, the display shows Last Mem
and you can resume playback (this works for
up to five discs).
If you want to clear the resume/last memory
point, press (stop) while Resume or Last
Mem is displayed.
• When a Video CD is loaded, the Resume
point is lost if the system is switched off, or
switched to a function other than DVD/CD.
• For the Last Memory function to work, you
must press
before opening the disc tray or changing
the disc.
• The Last Memory function doesn't work
with VR format DVD-RW discs.

Changing discs

You can change any of the discs not in the play
position using the EXCHANGE button on the
front panel. Because the disc in the play
position is unaffected, you can use this button
to change discs even during playback.
1 Press EXCHANGE to open the disc tray.
• The EXCHANGE button only works when
there is at least one disc loaded.
32
En
(stop) to stop playback
2 Load a disc with the label side facing
up, using the disc tray guide to align the
disc.
• If you want to load more discs, press DISC
SKIP to rotate the disc tray two disc spaces.
• Before loading or removing discs, always
wait for the disc mechanism to come to a
complete stop.
• Load discs only in the two fully accessible
disc spaces. Do not try and load discs into
any of the other spaces; they may not load
correctly and cause the system to
malfunction.
• Do not rotate the disc tray by hand. Always
use the DISC SKIP button.
• Do not obstruct the movement of the disc
tray.
3 Press EXCHANGE or
close the disc tray.
• Always use the
EXCHANGE button to close the disc tray
after exchanging discs. Never push the
disc tray shut by force.
• After I load a DVD disc, it ejects
automatically after a few seconds!
Disc number
OPEN/CLOSE to
OPEN/CLOSE or