Table of Contents
Advertisement
139 INITIALIZE: Mask settings are initialized to factory values for each application file. Simultaneously press the L
and R buttons for about 2 seconds to return the selected files to the factory settings. See Page 25 for the factory
settings of each application file.
12 OUTPUT/SYNC
On this menu screen, you can make signal changeover for output to the D-SUB connector and phase adjustment for
external synchronization.
1) OUTPUT:Output mode changeover
L L
R,G,B
R, G, B:The R, G and B video signals are output to the D-SUB connector.
Y, R-Y, B-Y:The Y, R-Y and B-Y signals are output to the D-SUB connector.
Y/C:The Y/C signal is output to the D-SUB connector. It can be delivered simultaneously with the Y/C signal
output from the Y/C connector (S terminal).
2) MONO: Monochrome (black and white) ON/OFF for the video output signal from the VIDEO connector
Set to ON for monochrome. Setting ineffective during color bar.
3) SYNC ON G: G video signal synchronization ON/OFF (In the R/G/B mode only)
When output is RGB with Sync on and G on, Sync is added to the G video signal.
4) GL IN: Impedance changeover of input to the GL IN connector.
HIGH:The high impedance level is provided.
75 :An impedance of 75 ohms is provided.
(Note) When power to the camera is turned off, the high impedance level is provided. So, do not use this
function in a system where power is turned off for the camera unit only.
5) GL MODE:
VBS:The VBS signal or BBS (black burst) signal is input as an external synchronizing signal.
HD/VD:The HD/VD signal is input as an external synchronizing signal.
(Note) During external sync with HD and VD signals, be sure to use either RGB or Y, B-Y, R-Y output
signals. Although VBS and Y/C output signals are also produced, these cannot be used as normal
output signals.
R R
Y,R-Y,B-Y
Y/C
27
Advertisement
Table of Contents
