Output/Sync - Hitachi HV-D20P Operation Manual

15. OUTPUT/SYNC

On this menu screen, you can make signal changeover for output to the D-SUB connector and phase
adjustment for external synchronization.
1) OUTPUT : Output mode changeover
• R, G, B
• Y, R-Y, B-Y
• Y/C
2) COLOR BAR : Color bars ON/OFF
3) MONO : Monochrome (black and white) ON/OFF for the video output signal from the VIDEO connector
Set to ON for monochrome. Setting ineffective during color bar.
4) Sync/HD out : Selects sync signal output from the rear panel multi connector.
5) SYNC ON G : G video signal synchronization ON/OFF (In the R/G/B mode only)
When output is RGB with Sync on and G on, Sync is added to the G video signal.
6) GL IN : Impedance changeover of input to the GL IN connector.
•
HIGH : The high impedance level is provided.
•
75Ω : An impedance of 75 ohms is provided.
Note: When power to the camera is turned off, the high impedance level is provided. So, do not use
this function in a system where power is turned off for the camera unit only.
：The R, G and B video signals are output to the D-SUB connector.
：The Y, R-Y and B-Y signals are output to the D-SUB connector.
：The Y/C and VBS signal is output to the D-SUB connector.
39