Id/Title - Hitachi HV-D25 Operation Manual

6) SC.COARSE:Coarse adjustment of subcarrier phase
0 • ‹
Using the L or R button, select one of the following phases; 0º, 90º, 180º and 270º.
7) SC.FINE:Fine adjustment of subcarrier phase
The allowable setting range is -128 to 127.
There is no direct relationship between a numeric value and a degree of phase. If the relevant range is exceeded,
the SC COARSE setting is updated automatically to permit continuous adjustment.
8) H.PHASE:Adjustment of horizontal synchronization phase
The allowable setting range is -128 to 127.
13

ID/TITLE

ID and title display position and data setting menu.
1) ID: ID display position setting
Once an ID is assigned, it becomes possible to control a particular camera unit remotely from a personal
computer according to its ID. That is, multiple camera units can be remote-controlled individually from one
personal computer.
At this function item, specify whether the ID is displayed on
screen or not. In case that the ID is displayed on screen,
specify its display position also.
OFF:Not displayed.
TOP:Displayed at the upper right corner of screen.
BOTTOM:Displayed at the lower right corner of screen.
2) At this function item, specify whether the TITLE is displayed
on screen or not. In case that the TITLE is displayed on
screen, specify its display position also.
OFF: Not displayed.
TOP: Displayed at the upper left corner of screen.
BOTTOM: Displayed at the lower left corner of screen.
2) DATA SET:The DATA SET screen comes up.
ID: Enter an ID code consisting of three characters.
Alphanumeric upper-case characters and a space character are permitted.
TITLE: Enter a TITLE consisting of up to 12 characters.
Alphanumeric upper-case characters, special symbols and a space character are permitted.
(Note) The symbol "
given as a blank in an ID code or TITLE.
L L R R
9 0 • ‹ 1 8 0 • ‹
" in the data represents a space character. On the actual screen, a space character is
2 7 0 • ‹
28
TOP TITLE
BOTTOM TITLE
ID/TITLE Display Position
TOP ID
BOTTOM ID