Output/Sync - Hitachi HV-D25 Operation Manual

13 INITIALIZE:
Simultaneously press the L and R buttons for about 2 seconds to return the selected files to the factory
settings. See Page 25 for the factory settings of each application file.

12 OUTPUT/SYNC

On this menu screen, you can make signal changeover for output to the D-SUB connector and phase
adjustment for external synchronization.
OUTPUT Output mode changeover
R, G, B The R, G and B video signals are output to the D-SUB connector.
Y, R-Y, B-Y The Y, R-Y and B-Y signals are output to the D-SUB connector.
Y/C The Y/C signal is output to the D-SUB connector. It can be delivered simultaneously with the
Y/C signal output from the Y/C connector (S terminal).
MONO Monochrome (black and white) ON/OFF for the video output signal from the VIDEO
connector
Set to ON for monochrome. Setting ineffective during color bar.
SYNC ON G G video signal synchronization ON/OFF (In the R/G/B mode only)
When output is RGB with Sync on and G on, Sync is added to the G video signal.
GL IN Impedance changeover of input to the GL IN connector.
HIGH The high impedance level is provided.
75 An impedance of 75 ohms is provided.
(Note) When power to the camera is turned off, the high impedance level is provided. So,
GL MODE
VBS The VBS signal or BBS (black burst) signal is input as an external synchronizing signal.
HD/VD The HD/VD signal is input as an external synchronizing signal.
(Note) During external sync with HD and VD signals, be sure to use either RGB or Y, B-Y,
Mask settings are initialized to factory values for each application file.
do not use this function in a system where power is turned off for the camera unit
only.
R-Y output signals. Although VBS and Y/C output signals are also produced, these
cannot be used as normal output signals.
25