Lanier LD225 Network Manual page 130

Monitoring and Configuring the Printer
Message
Printer <printer name> has no queue
pserver start. (NetWare)
Required file server (<file server name>) not
found
restarted.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
4
session <community name> already defined.
session_ipx <community name> not defined.
Set context to <NDS context name>
shutdown signal received. network service re-
booting...
smbd start. (NETBIOS)
SMTPC: failed to get smtp server ip-address.
SMTPC: failed to connect smtp server. time-
out.
SMTPC: refused connect by smtp server.
124
Problem and solutions
(In the print server mode) The print queue is
not assigned to the printer. Using NWadmin,
assign the print queue to the printer, and then
restart it.
(In the print server mode) The NetWare serv-
ice has started.
The required file server is not found.
The lpd service has started.
The SAP function has started. The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
The requested community name is not defined.
The requested community name is not defined.
An NDS context name has been set.
The network service is rebooting.
The smbd service has started.
The SMTP server IP address could not be ob-
tained. This could be because:
• The specified DNS server could not be found.
• No connection to the network has been es-
tablished.
• The specified DNS server could not be found.
• An incorrect DNS server is specified.
• The specified SMTP server IP address
could not be found in the DNS server.
Connection to the SMTP server failed due to
timeout. This could be because:
• The specified SMTP server name is incorrect.
• No connection to the network has been es-
tablished.
• The network configuration is incorrect, so
there is no response from the SMTP server.
Connection to the SMTP server is denied. This
could be because:
• A server other than the SMTP server has
been specified.
• The specified SMTP server port number is
incorrect.