Lanier LD225 Network Manual page 129

Message
IPP cancel-job: permission denied.
ipp disable.
ipp enable.
IPP job canceled. jobid=%d.
LeaseTime=<lease time>(sec), Renew-
Time=<renew time>(sec).
Login to fileserver <file server name>
(<IPX|IP>,<NDS|BINDERY|NDS|BIND-
ERY>)
Memory allocate error.
Name registration success. WINS Serv-
er=<WINS server address> NetBIOS
Name=<NetBIOS name>
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration failed. name=<NetBIOS
name>
nbtd start.
npriter start. (NetWare)
nwstart start. (NetWare)
Open log file <file name>
papd start. (AppleTalk)
phy release file open failed.
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
Print server <print server name>has no print-
er.
print session full
Problem and solutions
The printer could not authenticate the name of
the user attempting to cancel a job.
Printing with ipp is disabled.
Printing with ipp is enabled.
The spooled job was canceled due to error or
user request.
The resource lease time received from the
DHCP server is displayed in [lease time] in
seconds. The renewal time is displayed in [re-
new time] in seconds.
(In the print server mode) Login to the file
server is in the NDS or BINDERY mode.
Data cannot be obtained.
Disconnect the USB cable, and then connect it.
Name registration of <NetBIOS Name> to
<WINS server address> was successful.
Name registration by Broadcast name of <Net-
BIOS Name> was successful.
Name registration of <NetBIOS Name> failed.
Change to different NetBIOS name.
The nbtd service has started .
(In the remote printer mode) The NetWare
service has started.
The service for NetWare protocol stack setting
has started.
(In the print server mode) The specified log file
has been opened.
The AppleTalk print service has started.
Replacing the network interface board is re-
quired. Contact your sales or service repre-
sentative.
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.
(In the print server mode) The printer is not as-
signed to the print server. Using NWadmin,
assign the printer, and then restart it.
No more print jobs can be accepted.
Message List
4
123