Lanier LD225 Network Manual page 117

Messages
Near Replacing: Maintenance Kit
Nearly Full: Waste Toner
Need more Booklet Staples
No Paper: Interposer Tray
No Paper: Selected Tray
No Paper: Tray 1
No Paper: Tray 2
No Paper: Tray 3
No Paper: Tray 3 (LCT)
No Paper: Tray 4
Not Detected: B2 Lever
Not Detected: Black Toner
Not Detected: Cyan Toner
Not Detected: Develop. Unit (C)
Not Detected: Develop. Unit (K)
Not Detected: Develop. Unit (M)
Not Detected: Develop. Unit (Y)
Not Detected: Duplex Feed Unit
Not Detected: Duplex Unit
Not Detected: Finisher
Not Detected: Fusing Unit
Not Detected: Input Tray
Not Detected: Interposer
Not Detected: LCT
Not Detected: Magenta Toner
Not Detected: PCU
Not Detected: PCU (C)
Not Detected: PCU (K)
Not Detected: PCU (M)
Not Detected: PCU (Y)
Not Detected: Tray 1
Not Detected: Tray 2
Not Detected: Tray 3
Not Detected: Tray 3 (LCT)
Not Detected: Tray 4
Getting Printer Information over the Network
Description
Prepare the new maintenance kit.
Waste toner bottle is nearly full.
Stapler has almost run out of staples.
There is no paper in interposer unit.
There is no paper in specified tray.
There is no paper in tray 1.
There is no paper in tray 2.
There is no paper in tray 3.
There is no paper in tray 3 (Large Capacity tray).
There is no paper in tray 4.
B2 lever is not correctly set.
Black toner is not correctly set.
Cyan toner is not correctly set.
The development unit (cyan) is not correctly set.
The development unit (black) is not correctly set.
The development unit (magenta) is not correctly set.
The development unit (yellow) is not correctly set.
The duplex unit is not correctly set.
The duplex feed unit is not correctly set.
Finisher is not correctly set.
The fusing unit is not correctly set.
The paper feed tray is not correctly set.
Interposer unit is not correctly set.
A large amount of paper feed tray is not correctly set.
Magenta toner is not correctly set.
The photoconductor unit is not correctly set.
The photoconductor unit (cyan) is not correctly set.
The photoconductor unit (black) is not correctly set.
The photoconductor unit (magenta) is not correctly
set.
The photoconductor unit (yellow) is not correctly set.
Tray 1 is not correctly set.
Tray 2 is not correctly set.
Tray 3 is not correctly set.
Tray 3 (Large Capacity tray) is not correctly set.
Tray 4 is not correctly set.
4
111