Advertisement
OPERATION
OFYOU
[IPTICAL
GETTING
FAMILIAR
WITH THE CONTROL
PANEL
E98CONSOLE
PROGRAM BUTTONS_
(Manual, Hill,Fat B urn,
_
Cardi0, Strength, Interval,
Custom, Fit-Test, 2HR)
CONTROL
COOLING
FAN
_SPEAKER
_DATA
DISPLAY
DOTMATRIX
(Pr0gramPr0files)
MESSAGEWlNDOW
(Time,Program Name, D istance,
RPM, C alories, L aps,Level,
Incline,& Pulse)
POWER S WITCH
POWER UP
When power is connected
to the Elliptical the console will automatically
power up. These
models are connected
directly to 115 VAC and there is a power switch located where the line cord plugs into the
unit on the left side near the front (See page 4 for location).
When it is first powered on, the console will perform
an internal self-test. During this time all the lights will turn on.
When the lights go off, the Message window will show a software version (i.e.: VER 1.0) and the Calorie window
will
display an odometer
reading. The odometer
reading displays how many virtual
miles the elliptical
has gone. The
Time window
displays how many hours the elliptical
has been used.
The odometer
and time will remain displayed
for only a few seconds then the console will go to the startup display.
The dot matrix display will be scrolling through
the different
workout
profiles and the Message window
will be
scrolling the start up message. You may now begin to use the console.
!!ATTENTION
Your new elliptical
console might come configured
in an in-store 'display mode' of operation,
where the console will
remain powered on unless the main power switch is turned off. If this is the case, follow this procedure
to turn it off:
To exit the display mode, for normal operation,
press and hold the Stop, Enter and Display keys for five seconds;
the display will show: Display
Mode - ON. Use the Resistance Up key to change the setting to OFF then press
Enter
13
E98 ELLIPTICAL
Advertisement
