Advertisement
GENERAL I T
I. Wipe down
all areas in the sweat path with a damp
cloth after each workout.
2.
Ifa squeak, thump,
clicking
or rough
feeling
develops
the main cause is most likely one of
two reasons:
I.
The hardware
was not sufficiently
tightened
during
assembly.
All bolts that were
installed
during
assembly
need to be tightened
as much as possible.
It may be
necessary
to use a larger wrench
than the one provided
if you cannot
tighten
the bolts
sufficiently.
I cannot
stress this point
enough;
90% of calls to the service
department
for
noise issues can be traced to loose hardware
or the rear rails being dirty.
II.
Dirt build-up
on the rear rails and polyurethane
wheels
are also a source of noise.Noise
from build-up
on the rails can cause a thumping
sound
that you would
swear is coming
from inside the main body of the machine
because
noise travels, and is amplified
in the
tubing
of the frame. Clean the rails and wheels
with a lint free cloth and rubbing
alcohol.
Stubborn
build-up
can be removed
with your thumbnail
or a non-metallic
scraper,
like the back edge of a plastic
knife. After cleaning,
apply
a small amount
of
lubricant
on the rails with your fingers
or a lint free cloth.You
only need a thin coat of
lubrication,
wipe off any excess.
3.
If squeaks
or other
noises persist, check that the unit is properly
leveled
before
calling
the
service department.
MAINTENANCE
MENU
IN CONSOLE SOFTWARE
1.
Press and hold the Start, Stop and Enter key at the same time,
until the display
shows
"Maintenance
Menu". Press the Enter key.
2.
You can now scroll through
the menu
using the Resistance
Up/Down
keys. Use the Stop
key to return to previous
menu selection.The
menu
selections
are:
A.
Key Test
B.
Display Test
C.
Functions
I.
Display
Mode - Turn on to have the console
power down automatically
after 30 minutes of inactivity
II.
Pause Mode-
Turned on to allow 5 minutes of pause, turn off to have console pause in definitely
III.
ODO Reset - Resets the Odometer
reading to zero
IV. Units-
Choose from English(Imperial)
or Metric display readings
V.
PWM Test- For testing the Brake function
D.
Factory Settings
E.
Exit
Incline
Calibration:
If there
is a problem
with the incline, try running
the calibration.
Press the
Incline
Up key and the Start key at the same time.
Hold them down
for 5 seconds
and the
Incline
calibration
will start and run automatically.
If the problem
persists contact
Sole service
department.
E98 ELLIPTICAL
24
Advertisement
