Advertisement
CONNECTING
1.
Untie the wire holding the Sleeve Spacer (19) in place on the rod-end
bush-
ings, located on the ends of the connecting
arms (8 & 9). Align the hole in the
rod ends with the hole in the brackets of the left and right Handle Bar (10 &
11).The
rod end should be on the inside of the Handle Bar bracket. Secure
both sides with a Hex Head Bolt (114), Flat Washer (1S4) and Nyloc Nut (143)
by using the wrenches
provided
(169 & 187).
'
F
#154. 5/16"x
20 x 1.5T
Flat Washer (2 pcs)
#143. 5/16"x
7T
Nyloc Nut (2 pcs)
#114. 5/16"x
1-1/4"
Hex Head Bolt (2 pcs)
PLASTIC
1.
Match up the console covers (81 & 82) and secure with three Phillips head
screws (129) and two Sheet Metal Screws (132) using the short Phillips head
screw driver (170). Tighten the Sheet metal screws first.
2.
Match up the Connecting
Arm Covers (97 & 98-inner
covers and 95 & 96
-outer covers). Install the inner covers onto the Left and Right Connecting
Arms (8 & 9) and secure each side with two Phillips Head Screws (129) and
two Sheet Metal Screws (132) by using the Short Phillips Head Screw Driver
(170). Install the outer covers onto the left and right handlebars
(10 & 11)
and secure each side with two Phillips Head Screws (129) and two Self
Tapping Screws (132). Make sure the outer covers are positioned
in relation
to the arrow on each sticker.
3.
Install Sliding Wheel Covers (22) on each side and secure with four Phillips
Head Screws (129).
4.
Install the two Stabilizer Covers (101 & 102) on the middle stabilizer bar with
two Phillips Head Screws (129).
5.
Install the Front Stabilizer Cover (90) on the front stabilizer
with two Phillips
Head Screws (129).
6.
Install the two incline Cover brackets (20), with the hole for mounting
the
plastic cover on the bent tab facing rearward, and secure them on the Incline
Rail Assembly (2) with four Phillips Head Screws (131). Install the Rear incline
bar cover (100) on the rail base with two Screws (129).
7.
Install the Rear Stabilizer Cover (24) on the Rear Stabilizer with four Phillips
Head Screws (129).
8.
This step to be performed
after the elliptical
power is plugged
in. Run the
incline to position
8 and install the incline Rail front cover (99) up against the
middle stabilizer
tube with four Phillips Head Screws (129).
•
i
#132. 3.5 x 12mm Sheet
Metal Screw (10 pcs)
#129. M5 x 15mm
Phillips Head Screw
(29 pcs)
#131. M6x lOmm
Phillips Head Screw
(4 pcs)
#20. Bracket (2 pcs)
E98 ELLIPTICAL
10
Advertisement
