Cavity Preparation; Parts Supplied - Fisher & Paykel DishDrawer DD605 Installation Instructions Manual

Cavity preparation

4

Parts supplied

Drain hose Drain hose
support (1) joiner (1)
Hexagonal sockets (2)
(Long & Short)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorized Service Agent or www.fisherpaykel.com. DO NOT extend beyond this limit.
n b e l o c
r v i c e s c a
N o t e : S e
s h D r a w e
d e o f D i
e i t h e r s i
min. ø50 mm
These marks indicate mounting tab screw locations
* Preferred position. If adequate clearance, services hole can be higher to clear toe kick space.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Wire clip (2) Clamp (1)
Moisture
10 mm
protection
tape must
be applied.
a t e d
r ® .
*
Install Phillips Moisture
16 mm protection
tabs (2)
screws (9) tape (1)
(to prevent moisture
damage)
o
90
max. 450 mm
*
Prefinished toe kick (1)
White or Black
min. 200 mm
220-240 VAC
min. 9 A