Table of Contents
Advertisement
(2,1) -1- 590116A DCS DD24SU TALL installA2 USCA.indd 17/8/10 8:49:55 AM
(2,1) -1- 590116A DCS DD24SU TALL installA2 USCA.indd 17/8/10 8:49:55 AM
PARTS SUPPLIED
4
Drain hose
Drain hose
Wire clip (1)
support (1)
joiner (1)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 11' 10" (3.6m). The kit is available from the nearest DCS
Authorized Service Agent, or Toll free 1.888.936.7872 or www.dcsappliances.com.
5
CAVITY PREPARATION
Important!
Be sure the edges of the services hole are smooth or covered. If the services hole is through a metal
partition the hole must be protected with the Edge protector supplied to prevent damage to the
power cord or hoses.
These marks indicate formed bracket screw locations.
Note: To align drawer front to adjacent cabinetry, the product to countertop clearance can
be increased to 1⁄8"
3 mm).
(
*
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose is routed straight into the waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8" (9 mm) male compression fitting.
Water Pressure
Max
Water softener models
1 MPa (145 psi)
Other models
1 MPa (145 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you confirm
acceptability with your local rabbi in respect to kosher installations.
Max. distance of
Left hand
Right hand
hoses and cord from
side
side
chassis edge
Drain hose
78 ½ "
70 ½ "
(2000 mm)
(1800 mm)
Inlet hose
64 ¾ "
49"
(1650 mm)
(1250 mm)
Power cord
(excl. plug)
29 ½ "
27 ½ "
(750 mm)
(700 mm)
All manuals and user guides at all-guides.com
Side mounting
Top mounting
bracket kit
brackets (2)
(A and B) (2)
OPTIONAL
OPTIONAL
Min
0.1 MPa (14.5 psi)
0.03 MPa (4.3 psi)
Left hand
Right hand
side
side
Clamp (1)
Phillips
½
1
" (38 mm)
5⁄8
" (16 mm)
bottom
screws (7)
fixing screws
& metal
washers (2)
If no side partition,
use a brace for
securing.
Moisture
2" x 4"
3⁄8"
protection
tape must
(10 mm)
be applied.
max. ø
½
1
" (38 mm)
*
Rubber
Moisture protection
Edge protector (1)
(if services hole
washer for
tape (1)
partition is metal)
inlet hose (1)
(to prevent moisture
damage)
r v ic e s c a
N o t e : S e
e o f D is h
e it h e r s id
*
max.
11⁄16
17
"
(450 mm)
Water supply
Important!
110-120 VAC
Adjacent cabinetry must not
max. 15 A
extend above cavity base
a t e d
n b e lo c
.
D r a w e r ®
min.
7⁄8
7
"
(200 mm)
Advertisement
Table of Contents
