Advertisement
COUNTERTOP
Moisture
3/8"
protection tape
(10 mm)
must be applied
These marks indicate formed
bracket screw locations, if
securing by drawer removal.
If there is no side partition, you
can construct timber bracing
as something to secure into.
WARNING!
Incorrect placement of the hole
will result in damage to hoses.
Max 1/4" (5mm)
Max distance
between hole edge
and rear inner face
Hoses
Power
cord
Max 1/2" (10mm)
Max distance between
hole edge and floor
7
6
CAVITY PREPARATION
Service Holes
Can be located either side of dishwasher, close to the rear face and the
floor, as illustrated, for access to the water supply, drain and power outlet.
The small hole is for the power cord only.
If the hole is through wood, make sure its edges are smooth and rounded.
If the hole is through metal, ensure you fit the supplied Edge Protector to
prevent damage to the power cord.
max. 17 11/16"
(450 mm)
Ø 2 1/4"
(57 mm)
Ø max. 1 1/2"
(38 mm)
Water Connection
Recommended HOT
(Maximum 140°F/60°C).
Supplied hose to suit 3⁄ 8 " (9 mm)
male compression fitting.
Water Pressure
Water softener models
Max. 1 MPa (145 psi)
Min. 0.1 MPa (14.5 psi)
Models without water softener
Max. 1 MPa (145 psi)
Min. 0.03 MPa (4.3 psi)
Kosher requirements
Drains will need to be separated
to satisfy kosher requirements.
We suggest you confirm
acceptability with your local rabbi
in respect to kosher installations.
IMPORTANT!
The power outlet must be located in
a cabinet adjacent to the dishwasher
cavity. 110-120 VAC max. 15 A
Advertisement
