Final Checklist - Fisher & Paykel DishDrawer DD605 Installation Instructions Manual

Final checklist

24
Check all parts are installed.
Ensure product is level, securely fastened to the cabinetry and opens and closes freely. The
DishDrawer® must be free to fully close with no resistance from the cabinetry.
Ensure inlet hose to water supply has rubber washer fitted and is tightened a further half turn
after seal contact.
Ensure any knockouts or plugs in drain connection have been drilled out and drain connection
has been made.
The drain hose connector must not support the weight of excess hoses. Keep hoses as fully
extended as possible to prevent sagging. Any excess length of hose should be kept on the
dishwasher side of the high loop.
If using Plumbing and Drainage OPTION 2, ensure the Highloop is a minimum 150 mm
higher than the drain hose connector.
Turn on the power and water supply. Then press the power button to turn the DishDrawer® on.
The DishDrawer® should beep and cycle select lights light up.
Check the sprayarm(s) are in place and free to rotate.
Spray arm
Add three cups of water into the DishDrawer®.
On the Wash Programme Selector Panel press Rinse
and close the drawer(s). Start the programme by pressing
the Start/Pause button.
After the Rinse programme has finished, ensure machine has run and drained correctly.
Check water supply and drainage connection for leakage.
Repeat for each Drawer.
Troubleshooting
Excessive water remaining above the filter plate, after the rinse cycle
Check for kinked drain hoses or blocked waste connection, high loop not properly installed or
drain hoses not routed correctly.
No water supply ( shows on display)
Check water is connected, turned on and the spray arm(s) is correctly fitted and free to rotate.
DishDrawer® does not light up when the tub is opened
Ensure power is connected and is switched on. Check if Auto Power option is on.
Water around water supply and drainage connections
Check connections, existing plumbing and hoses for leaks. Check washer and hose clamps are
correctly fitted.
If product is tipping
Ensure the product is secured to the cabinetry. Refer to page 7 or 18.
If front panels are misaligned
Check and relevel product. Check the cabinetry is square.
Drawer(s) don't close properly
Ensure nothing is obstructing the drawer(s) from closing properly ie sound insulation, hoses or
tub latches.
If a problem occurs, consult the Troubleshooting section of the User Guide.
If after checking these points you still need assistance, please refer to the Service & Warranty
book for warranty details and your nearest Authorized Service Centre, or contact us through our
website, www.fisherpaykel.com.