Cavity Preparation - Fisher & Paykel DishDrawer DD605 Installation Instructions Manual

Cavity preparation

16
Cavity
Drain hose Drain hose
support (1) joiner (1)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit
P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorized Service Agent or www.fisherpaykel.com. DO NOT extend beyond this limit.
n b e l o c
r v i c e s c a
N o t e : S e
s h D r a w e
d e o f D i
e i t h e r s i
min. ø50 mm
These marks indicate mounting tab screw locations
Note: To align drawer front to adjacent cabinetry, the product to counter top clearance can be
increased to 3 mm.
*
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Clamp (1)
Wire clip (1)
Moisture
10 mm
protection
tape must
be applied.
a t e d
r ® .
*
Important!
Adjacent cabinetry must not
extend above cavity base
Phillips 16 mm Moisture protection tape (1)
screws (5) (to prevent moisture damage)
o
90
*
max. 450 mm
min. 200 mm
220-240 VAC
min. 4.5 A