Receiver Reception - LG CodePlus OAT100R Installation & Setup Manual

If one or more receivers have symptoms of broken audio or video or no signal, refer to the
troubleshooting flow charts below and on the following pages. If necessary, contact LG for
additional troubleshooting help.
Broken Audio/Video on
Tuner or No Signal
Verify that the antenna(s)
are installed and pointed
properly.
Access the OAT100R Tuner
Information display (via GUI
or command line).
Check that all applicable tuners
are powered ON and locked to
an antenna signal, and then
check the signal-to-noise ratio,
FEC errors, and input bitrates
for each tuner.
Tuner input
data OK?
No
206-4218
Note: In the GUI, the Tuner Information
display provides data for each of the
OAT100R tuners. If using the command
line interface, you will be able to access
one tuner's information at a time.
Note: For each tuner, the signal-to-noise
ratio should be greater than 18, there
should be zero (0) FEC errors, and the
input bitrates should equal 19.4 Mbps.
Yes
Go to
Chart A
Troubleshooting (Cont.)
For example:
• Check the antenna cabling. Ensure that each cable is good and
that connections are secure both at the antenna distribution center
and at the OAT100R. Fix and verify as necessary.
• Ensure the antenna is pointed so as to achieve the best signal
quality.
• Ensure the signal level at each OAT100R RF input is balanced
within the recommended range (see OAT100R Setup Information).
• If applicable, check that the amplifier/splitter is operating properly.
necessary, reconfigure the
tuner channels as described

Receiver Reception

Check that the tuner
channels are valid. If
in this document.
Check
receiver(s). Problem Yes
Problem
solved?
solved?
No
No
Contact LG support.
End
69