LG CodePlus OAT100R Installation & Setup Manual page 70

Troubleshooting (Cont.)
Receiver Reception (Cont.)
Access the OAT100R System
Status (via GUI) or System
A
Monitor (via command line)
display and observe the
system configuration data.
Check that the OAT100R output
mode (RF or IP) is properly
configured. If necessary,
reconfigure the output mode as
described in this document.
Check
receiver(s). Problem
Problem
solved?
solved?
Redisplay the OAT100R
System Status (via GUI) or
System Monitor (via command
line), and check the ouput
bitrates for each tuner.
Bitrates at
ideal level for
all tuners?
70
Yes
End
No
Note: Typically, output
bitrates should be greater
than 1 Mbps.
Yes
Go to
Chart C
No
For each tuner, access the
Tuner Menu (via GUI) or Tuner
Information display (via
command line), and make sure
at least one program is enabled
for each tuner channel.
If applicable, enable one or
more programs on each tuner.
Check
receiver(s). Problem
Yes
Problem
solved?
solved?
No
Go to
Chart B
End
206-4218