LG CodePlus OAT100R Installation & Setup Manual page 44

Configuration Options via Command Line (Cont.)
Note: When a tuner is powered ON from a power OFF state, the Status field of the Tuner
Information display reflects the progress of the power ON process, which may take up to 90
seconds as tuner firmware is reloaded. During the power ON process, the Status field shows
"Initializing," and once the process is complete, the Status field shows "Streaming." A viewable
stream appears 10 to 15 seconds after the tuner status changes to "Streaming."
Monitor the System
This option enables you to view static or dynamic system streaming data and is also available
from the OAT100R Main Menu and the Setup Menu.
At the Tuner Command > prompt, either:
• Type monitor and press Enter to display the current system data (see sample display
under the "Monitor the System" section on page 40).
• To monitor streaming data in real time, type monitor and the number of seconds before
the data refreshes. Then, press Enter. For example, to refresh the data every second, type
monitor 1 and press Enter.
When you are finished monitoring streaming data, press Enter to stop the system monitor
and return to the Tuner Command > prompt.
View the System Program Map
This option enables you to display program assignments for each tuner and is also available
from the OAT100R Main Menu and the Setup Menu.
At the Tuner Command > prompt, type map and press Enter to display the current system
program assignments (see sample display under the "View the System Program Map" section
on page 41).
Set the Tuner Channel
The terrestrial channel range is 2 to 69.
1. At the Tuner Command > prompt, type channel and press Enter.
2. At the Enter channel [#]> prompt, either:
• Press Enter to accept the default value in square brackets, or
• Type in a new channel number and then press Enter.
Note: If you enter channel "1" or a channel number that is higher than "69," the system will
display an "invalid channel" message and then return to the Tuner Command > prompt.
Note: To specify "no connection," type 0 at the channel prompt and press Enter.
44
(Continued on next page)
206-4218