Tuner Menu Commands - LG CodePlus OAT100R Installation & Setup Manual

Configuration Options via Command Line (Cont.)

Tuner Menu Commands

The following subsections describe how to access and use the Tuner Menu commands.
Access the Tuner Menu
1. Log in to the OAT100R as described on page 39.
2. At the Command > prompt, type tuner and press Enter.
3. At the Enter Tuner number [0] > prompt, type the number of the OAT100R X-Port
connected to the tuner for which you wish to view/modify configuration. Then, press
Enter.
The system identifies the current tuner and then displays a Tuner command prompt, for
example:
Current Tuner: Tuner-1
Tuner-1 Command >
4. At the Tuner Command > prompt, either:
• Press Enter to display the Tuner Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the Tuner Command > prompt to display the Tuner
Menu.
Example: Tuner Menu
----------
Tuner Menu
----------
tuner Change Tuner
info Tuner info
monitor System monitor
map System program map
channel Set channel
prog Select programs
output Output stream
on Turn Tuner On
off Turn Tuner Off
reset Reset Tuner
exit Return to the main menu
Tuner-1 Command >
42
206-4218