LG CodePlus OAT100R Warranty Welcome to the LG family! We believe that you will be pleased with your new CodePlus OAT100R Broadcast Products Off Air Transcoder System. Please read this warranty carefully, it is a “LIMITED WARRANTY” as defined under Federal Law. This warranty gives you specific legal rights, and you may also have other rights that vary from state-to-state within the U.S.A.
CAUTION: so, subject to the following conditions: Copyright © 1999 Dug Song Do not attempt to modify this product in any way without written authorization from LG Copyright © 1999 Aaron Campbell SUBJECT TO THE TERMS OF THE GPL VERSION Electronics U.S.A., Inc.
When a cart is used, use caution when 20. Test Equipment moving the cart/apparatus combination In some cases, LG has supplied or recom- in order to avoid injury from tip-over. mended the use of test equipment and devices for the setup and testing of the equipment. The 13.
IMPORTANT SAFETY INSTRUCTIONS Speciﬁ cations 24. Safety Check (Continued from previous page) Dimensions Upon completion of any service or repairs to Height: 1.692 inches (42.977 mm) this product, ask the service technician to 21. Damage Requiring Service Width: 19.0 inches (482.6 mm) with mounting brackets attached Unplug this product from the wall power out- perform safety checks to determine that the (for EIA standard 19-inch rack mount)
Troubleshooting IMPORTANT SAFETY INSTRUCTIONS This section provides introductory OAT100R installation and setup troubleshooting E. Mains Outlet Earthing (Continued from previous page) information. Refer to the extended Installation & Setup Guide for additional trouble- The apparatus with Class I construction must be connected to a mains socket outlet with a shooting information.
System Setup (Cont.) (Continued from previous page) The LG CodePlus™ OAT100R Off Air Transcoder System provides a flexible solution for system providers who provide terrestrial delivered DTV content to commercial facilities 24. At the next Tuner Command > prompt, type info and press Enter, and then check (hotels, hospitals, etc.).
VHF and/or UHF antennas must be installed before you proceed to set up the The system will identify the current tuner and then display a tuner command prompt, OAT100R. LG recommends that the system be professionally installed. for example: Check the following items before you begin OAT100R installation and setup procedures.
Setup Information (Cont.) System Setup (Cont.) Channel Assignments for RF Output (Continued from previous page) __ Create a channel assignment plan for the installation site, or modify an existing plan e) Repeat steps (c) and (d) for each of the additional three tuners, as required. to incorporate the RF output of the OAT100R.
Enter to remap the tuner output to a different stream. Refer to the CodePlus OAT100R Off Air Transcoder System Installation & Setup The system will display conﬁ rmation, for example: Guide for further installation and conﬁ guration information.
Rear and Front Panel Overviews System Setup (Cont.) (Continued from previous page) OAT100R Rear View Note: If you change the Control Port configuration, you will be prompted to reset the system. If you intend to modify additional configuration settings during the current session, you may wait until all changes are complete before you reset the system.
System Setup (Cont.) Rack Installation (Continued from previous page) Typical Rack Installation 1. (Optional) As shipped, the OAT100R mounting brackets are attached ﬂ ush with the 13. (IP output only) Complete OAT100R IP output configuration as follows: front of the unit (see diagram a). If desired, the mounting brackets may be detached a) If the Command >...
Rack Installation (Cont.) System Setup (Cont.) (Continued from previous page) c) At the prompt, type the number that corresponds to the appropriate output mode and press Enter. Front View The system will conﬁ rm your selection, for example: of Rack Cabinet 1 inch minimum Output mode is set: IP SERVICE...
In some instances, configuration steps must be performed before physical connections are made. OAT100R CodePlus Off Air Transcoder System Typical Setup Flow Chart for OAT100R with RF Output Copyright (c) 2010-2012 LG Electronics U.S.A., Inc. Copyright (c) 2010-2012 Zenith Electronics LLC 201-12301011 Version Distribution...
Enter to refresh the screen.) 7. At the login as: prompt, type admin and press Enter. Then, type the admin user password (provided by LG) at the password: prompt. 8. At the Command > prompt, type info and press Enter. (Note that you can press Enter at any OAT100R command prompt to view current menu.)