LG CodePlus OAT100R Installation & Setup Manual page 17

(Continued from previous page)
The initial System Information display identifies OAT100R default configuration settings,
including the Control Port IP address, the PID configuration, and the output configuration,
for example:
OAT100R
CodePlus Off Air Transcoder System
Copyright (c) 2010-2012 LG Electronics U.S.A, Inc.
Copyright (c) 2010-2012 Zenith Electronics LLC
SN:
Version
HW id:
Ctrl MAC:
Ctrl IP:
Program PIDs:
Output:
RF config:
RF channels:
Local time:
9. Check the Ctrl IP (Control Port IP address) field in the System Information display. By
default, the OAT100R uses DHCP; thus, the DHCP server, if configured, assigns an IP
address to the OAT100R once the OAT100R successfully connects to the network.
• If the Ctrl IP field shows an IP address, the OAT100R is up and running on the network.
Continue with step 10.
• If the network is configured for DHCP but the Ctrl IP field is blank, refer to "Network Setup"
troubleshooting information on page 67.
• If the network is not configured for DHCP, you will need to configure a static IP address
for the OAT100R. Complete steps 10 to 13 (as required), and then set the OAT100R IP
address using the commands indicated in step 14.
10. Check the Output field in the System Information display. If the default value (RF) does not
identify the appropriate output type, set the output mode as follows:
a) At the Command > prompt, type setup and press Enter to access the Setup Menu.
b) Use the Setup Menu "omode" command to set the appropriate output mode. See "Set
the Output Mode" on page 49 for further information.
11. The next step depends on the output mode:
• If you are setting up the system for RF output, continue with step 12.
• If you are setting up the system for IP output, go to step 13.
206-4218
201-12301011
1.9
12-19
00:0C:63:3A:FF:EC
10.166.60.92
0x30 - 0x6f
RF
Mode 2, 256-QAM-B, RF: 6 MHz, 5.36 MSps
2 3 4 5
Wed Oct 17 14:42:02 CDT 2012
System Setup (Cont.)
(Continued on next page)
17