Troubleshooting; Oat100R Setup - LG CodePlus OAT100R Installation & Setup Manual

The following sections provide basic troubleshooting information for the OAT100R.
Equipment Setup Review
• Make sure all connectors and connections are tight and secure on all entertainment system
components.
• Check the OAT100R LEDs:
− Under standard operating conditions the PWR (Power) LED on the OAT100R front panel
is continuously lit green. If there is a hardware fault, the PWR LED will turn and stay red.
(When power is first applied to the OAT100R, the PWR LED initially flashes red and then
turns green.)
− When the OAT100R is booted and operating normally, the STATUS LED is continuously lit
green.
Network Setup
If the network is configured for DHCP but the OAT100R has not been assigned an IP
address, i.e., the Ctrl IP field in the OAT100R System Information display is blank:
1. Check the Control Port connector on the rear panel of the OAT100R. Make sure the cable
connection is tight and secure.
2. Observe the green LED on the Control Port. Once the OAT100R is connected to the
network, the LED will be lit continuously.
3. Contact the network administrator to verify the network status and check that the DHCP
server is working properly.
206-4218

Troubleshooting

OAT100R Setup

67