Default Setting - SATO CT4i Series Operator's Manual

4.4.3 Default Settings Mode (ONLINE + FEED + POWER ON)
Turning the printer ON in this mode simply resets major settings to their default values. (See table). After
the default values have been restored, the printer emits three beeps. The ERROR LED also lights up
during the reset operation, but goes off after the settings have been activated.
Parameter
Reference position
Pitch offset
Cut position offset
Dispensing position offset
Tear off position offset
Label size (Pitch, width)
Print speed
Print darkness
Sensor type
Kanji character code
Paper end detection means
Zero slash
Proportional pitch
Buzzer
Initial feed
Auto-feed
Gap size
Optional operation modes
VR (Potentiometer)
Interface settings
CT4i Series Operator Manual
Unit 4: Printer Configuration
Vertical: 0dot, Horizontal: 0dot
0 dot
0 dot
0 dot
0 dot
Pitch=3200 dot x width 832dot [8dots/mm]
Pitch=4800 dot x width 1248dot [12dots/mm]
Pitch=9600 dot x width 2496dot [23.6 dots/mm]
100 mm/s [8dots/mm] [12dots/mm]
50 mm/s [23.6dots/mm]
3A [Direct thermal]
3B [Thermal transfer]
Gap
JIS
Roll type
Enable
Enable [CT Series]
Enable
Disable
Disable
24dots [8dots/mm]
36dots [12dots/mm]
72dots [23.6dots/mm]
Operation No. 1
Option stop position offset =0, print darkness=0
IEEE1284: Multi buffer, ACK width =500ns
RS-232C: Baud rate=19200bps, Data-bit=8bit, Parity=off, Stop bit=1bit, Con-
trol=READY/BUSY control (multi- buffer)
LAN/Wireless LAN: Driver exclusive protocol (Status 4) cycle response mode (2-
port connection using Port 1024 and Port 1025, or 1 port connection using Port
9100.)
USB: (no default settings)
Bluetooth: Bluetooth mode = Status 4, PIN code = 0000000000000000, Authenti-
cation mode = Authentication Level 1, ISI=0800, ISW=0012, PSI=0800, PSW=0012,
Device name = SATO ONLINE PRINTER, CRC Check = Disable
4-10

Default Setting