Default Setting Mode - SATO M-8400RVe Operator And Technical Reference Manual

Section 3: Configuration
INITIALIZING
ROM V00.00.00.00
TEST PRINT MODE
CONFIGURATION
TEST PRINT SIZE
10 CM
Note: This display does
not appear when a
Memory Test Print is
chosen. Only a small
Memory Test Print label
can be printed.
PRESS FEED KEY
TO STOP PRINTING

DEFAULT SETTING MODE

Occassionally it is desirable to reset all printer configuration settings to their original
default conditions. This allows the operator to start reconfiguration of the printer
starting from a know set of conditions.
INITIALIZING
ROM V00.00.00.00
DEFAULT SETTING
YES
DEFAULT SETTING
COMPLETED
Page 3-24
This option allows you to print a test label. It is recommended
that you print a test label after you have changed any of the
settings in the Advanced Mode. The test label allows you to
verify that you indeed did make the desired changes. To enter
the User Test Print Mode, power the printer on while pressing
the FEED key. The printer will beep. Release the FEED key
and the printer will display the Test Print Mode message on the
LCD panel:
1. Use the LINE key to step the underline cursor to type of
test label you wish to print. The choices are:
Once you have selected the type of test label to be printed, use
the FEED key to accept the selection and the display advances
to the Test Print Size display. This display allows you to select
the label width.
1. Use the LINE key to select the label width. Each time the
LINE key is pressed, the label size advances 1 cm until it
reaches a maximum width of 10 cm, at which point it will
wrap to the smallest size of 4 cm.
2. Pressing the LINE key accepts the selection.
3. Press the FEED key to start printing test labels
continuously.
4. Press the FEED key to stop the printer.
5. To exit the Test Print Mode, power the printer off and then
back on.
You enter the Default Setting Mode by pressing the LINE and
FEED keys while simultaneously powering the printer on. The
printer will emit one long beep after which the FEED and LINE
keys should be released.
1. Use LINE key to select either the YES or number
NO
2. Once the desired setting is selected, pressing the FEED
key will accept the selection and the printer will reset to
the original default conditions.
3. When the printer has completed the reset process, the
Default Setting Completed display will appear. At this time
the printer is in the default configuration.
4. To exit the Default Setting Mode, power the printer off and
then back on.
PN 9001075A
Configuration
Bar Code
Head Check
Memory
Factory
SATO M8400RVe