SATO CT4i Series Operator's Manual page 45

4.4.2 User Test Print Mode (FEED + POWER ON)
This mode produces test labels for diagnostic purposes. Upon entering this mode on startup, release the
FEED button. A beep is then produced, and the ERROR LED will light up.
When labels have been loaded properly, press the ONLINE or FEED button to start printing. Pressing
the FEED button produces small test label data, while the ONLINE button produces a big test print.
The ERROR LED goes off during the test printing. Pressing the FEED button at any time during the test
print operation will pause or resume the print job.
Note: To end the test print, make sure to press the FEED button to pause the printing, then turn the
printer OFF.
The following data will be produced on the test print:
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
For a picture of the print sample, refer to "test label printing" on page 5-8.
CT4i Series Operator Manual
Unit 4: Printer Configuration
Table 3: Data found on Test Prints
Base reference point offset (Vertical, horizontal)
Pitch offset
Cut position offset
Dispensing position offset
Tear off position offset
Label size (Pitch, width)
Print speed
Print darkness
Sensor type
Kanji character code
Paper end detection method
Zero slash
Proportional pitch
Buzzer
Initial feed
Interface settings
Type, buffer control, protocol, communication settings
Dip switch input/output function
Protocol code setting value
Euro-code (CT Series)
Data Printed
4-9