Adjusting The Picture Orientation; Anamorphic Lens Installation; Whitney Anamorphic Lens Mounting Assembly - Exploded View - Runco 3Dimension D-73d Ultra Installation & Operation Manual

Installation
Adjusting the Picture
Orientation
Anamorphic Lens
Installation
When you have completed the primary lens adjustments (D-73d/CineWide with
AutoScope only): Remove the anamorphic lenses and set the lens transport motor
power switch to the "on" position.
By default, the D-73d is configured for a "floor/front" installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu.
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
D-73d/CineWide - Whitney Anamorphic Lens Installation: The D-73d "Whitney"
Anamorphic lens mount kit consists of everything shown in Figure 3-26. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23-RUNCO.
1
Whitney
Anamorphic
Lenses (2x)
CineWide Base Plate
for Whitney Lens
Figure 3-26. Whitney Anamorphic Lens Mounting Assembly - Exploded View
56
2 Anamorphic Lens
Holder
3 Height/Pitch
Adjustment
Knobs (4x)
¼-20 Hex Bolt
4
and Washer (2x)
5 Yaw/X-adjustment Lever
and Washer (2x)
D-73d Series Installation/Operation Manual