Runco 3Dimension D-73d Ultra Installation & Operation Manual page 100

Operation
Copy/Paste
Memory Preset
Aspect Ratio
Memory Preset
Copy Settings
Paste Settings
Copied From:
Input Source HDMI 1
Signal Format 1080p/60
Memory Preset ISF Night
Copy/Paste
Memory Preset
Aspect Ratio
Aspect Ratio
Copy Settings
Paste Settings
Copied From:
Aspect Ratio 16:9
Screen Screen 1
Copy/Paste - Memory Preset: You can copy and paste settings from one memory
preset to another. This gives you a convenient starting point for creating a new preset
based on an existing one, to make the calibration process less time-consuming.
For example, you can use the Copy/Paste Memory Preset feature to:
• Apply settings from HDMI 1 to HDMI 2, or from HD1 to HD2.
• Calibrate an input for 720p source signals, then use those settings for 1080i sources.
• Duplicate ISF Night settings for a given source and signal format and save them in the
Custom 1 memory preset.
To use this feature, select Copy/Paste from the Calibration menu, then select Memory
Preset.
• Memory Preset - Copy Settings: Select Copy Settings from the Copy/Paste
Memory Preset menu to place the settings for the current input source, signal format
(resolution and frame rate) and memory preset onto a "clipboard," which is a temporary
memory location. When you do, the message "Settings Copied" briefly appears
on-screen. The Copy/Paste menu then re-appears, indicating the source of the copied
settings.
Copied settings are not retained after a power cycle.
Note
• Memory Preset - Paste Settings: To apply the settings on the clipboard to a
different input source, signal format and/or memory preset, do any or all of the
following:
• Switch to another input (for example, from HD1 to HD2).
• Change the output signal format at the source (for example, from 720p/60 to
1080i/60).
• Switch to another Memory Preset (for example, from ISF Night to Custom 1).
Then, select Paste Settings from the Copy/Paste Memory Preset menu. If you want
to keep these new settings, you must save them! (Refer to Save ISF Night/Save
ISF Day on page 83 or Memory Presets on page 76.)
Copy/Paste - Aspect Ratio: You can also copy and paste certain settings, such as
those for Output Shift and Image Alignment (refer to page 85) from one aspect ratio or
"screen" (refer to Screen on page 70) to another.
To do this, select Copy/Paste from the Calibration menu, then select Aspect Ratio.
• Aspect Ratio - Copy Settings: Select Copy Settings from the Copy/Paste Aspect
Ratio menu to place the Output Shift and Image Alignment settings for the current
aspect ratio onto a "clipboard," which is a temporary memory location. When you do,
the message "Settings Copied" briefly appears on-screen. The Copy/Paste menu then
re-appears, indicating the source of the copied settings.
Copied settings are not retained after a power cycle.
Note
84 D-73d Series Installation/Operation Manual