Setting The Spool Of Thread; Winding The Bobbin - Janome Sewing Machine Getting Started Manual

1
3
4
6

Setting the Spool of Thread

Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown. Attach the large spool holder, and press it firmly
against the spool of thread.
NOTE:
Use the small spool holder to hold narrow or small
spools of thread.
Extra spool pin
Use the extra spool pin when you need to wind a
bobbin without unthreading the machine while working
on a sewing project.
Insert the extra spool pin into the spool supporter and
then into the hole beside the horizontal spool pin.
Place the felt cushion on the spool pin and place a
spool of thread on it as shown.
NOTE:
2
The extra spool pin is also used for twin needle
sewing.

Winding the Bobbin

This machine has an exclusive motor for bobbin
winding, which allows you to wind the bobbin while
stitching.
1 Slide the hook cover release button to the right, and
remove the hook cover plate.
2 Lift out the bobbin from the bobbin holder.
3 Pull the thread from the spool and pass the thread
through the thread guide.
Draw the thread around and under the bobbin
winding tension disk.
4 Pass the thread through the hole in the bobbin from
the inside to the outside.
5
5 Put the bobbin on the bobbin winder spindle.
Push the bobbin winder stopper to the left.
6 Hold the free end of the thread in your hand and
press the bobbin winding button
Press the bobbin winding button again to stop the
bobbin when it has wound several layers, and cut
the thread close to the hole in the bobbin
NOTE:
Use the Janome plastic bobbins for horizontal hook
(marked with "J"). Using other bobbins, such as
prewound paper bobbins, may cause stitching problem
or damage to the bobbin case.
10
.
.