Janome Sewing Machine Getting Started Manual page 20

SET2 SET2
1
inch/mm
2
Touch Screen Calibration
Format
Built-in Memory
3
ATA PC Card
USB Memory
4
Reset all to defaults
(A)
Touch Screen Calibration
PRESS MARK (+).
Format Memory?
All the stored data will be erased.
inch
mm mm
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
X
Register Register
(B)
Touch Screen Calibration
END
Built-in
X
1 Inch/mm options
You can set your machine's measuring unit to either
inch or millimeter by pressing the "inch" or "mm" key.
The default unit setting is millimeter.
2 Touch screen calibration
If you think the touch panel keys are out of alignment,
you can correct it in the key position adjustment
window.
When you press the key, window (A) will be shown.
With your finger, press the black cross as it appears in
order. When you press the last black cross, the window
(B) will be shown. The window will close and go back to
the original screen with the new setting being
registered.
3 Formatting the memory
If the internal memory, ATA PC card or USB memory
key does not function due to damage to the memory
bank, you need to re-enable it by formatting the
memory.
4 Resetting all to default
Press the yes key to reset all the parameters to the
original values (factory settings).
21