Attaching The Spool Cap And Net; Raising Or Lowering The Presser Foot; Up/Down Needle Position Key; Screen Sharpness Adjusting Knob - Janome CompuLock Instruction Book

1
1
2
1
1
2
3
4
5
2
1

Attaching the Spool Cap and Net

1 When you use a small thread spool, remove
the spool holder from the spool pin.
Then place the spool with its slit side up, and
put a spool cap on top.
2 If the thread slips down from the spool while
threading or sewing, put a net on the
spool, as illustrated, to prevent jamming.
The nets are supplied with the machine.
1 Spool holder
2 Spool cap
3 Slit
4 Spool pin
5 Net

Raising or Lowering the Presser Foot

By raising or lowering the presser foot lifter,
the presser foot goes up and down.
* While in operation, keep the presser foot
lowered except for when threading the
machine.
Thread tension will be released when the presser
foot lifter is raised.
1 Presser foot lifter
2 Presser foot

Up/Down Needle Position Key

Press the Up/Down needle position key to bring
the needle to its lowest position.
When pressed again, the needle goes up and stops
in the highest position.
1 Up/down needle position key

Screen Sharpness Adjusting Knob

The brightness of the screen can be changed by
turning the sharpness adjusting knob.
1 Screen sharpness adjusting knob
8