Adjustment Of Cutting Width - Janome CompuLock Instruction Book

1

Adjustment of Cutting Width

When the cutting width is too narrow or too
wide in relation to the seam width, adjust it
as follows:
1 Turn off the power switch and unplug the
machine.
2 Open the looper and side covers.
3 Turn the cutting width adjusting dial to move
the cutting blades to the desired position.
1 Cutting width adjusting dial
2 Lower knife
3 Standard setting
2
3
2
If the cutting width is too narrow, turn the
cutting width adjusting dial clockwise.
The lower knife will move right.
If the cutting width is too wide,turn the cut-
ting width adjusting dial counterclockwise.
The lower knife will move left.
4 Close the looper and side covers.
48