Wrapped Overlock 3; Cover Stitch - Janome CompuLock Instruction Book

6
7

6. WRAPPED OVERLOCK 3

Needle setting position: LB (left back)

7. COVER STITCH

Needle setting position: LF (left front)
* The threading procedure that you can choose
the needle thread first or the double chain looper
thread.
The end of thread after threading the double
chain looper should be pulled out 5 cm (2") from
the double chain looper downward for ready to
sew.
Place the needle thread under the presser foot.
* To begin with, raise the presser foot and place
the fabirc at the desired start position.
Lower the presser foot and start to sew.
* To finish sewing, stop the machine at the desired
position on the fabric and raise the needle bar
to its highest position. Raise the presser foot so
that the thread tension unit will release.
Loosen the needle thread tension so that you
can pull the fabric easily.
Hold the edge of fabric and pull out 5 cm (2")
from machine and cut both needle threads
close to the fabric.
Next, pull the fabric to the back and cut off the
looper thread.
33
RB (right back)
RF (right front)