Mounting The Transceiver; Optional Ut-109 Or Ut-110 Installation - Icom IC-F1710 Instruction Manual

n Mounting the transceiver
The universal mounting bracket supplied with your transceiver
allows overhead mounting.
• Mount the transceiver securely with the 4 supplied screws to
a thick surface which can support more than 1.5 kg.
Nut
Flat washer
Felt*
Spring washer
Felt*
When using
self-tapping screws *Felts reduce the vibration effects.
CONNECTION AND MAINTENANCE
n Optional UT-109 or UT-110
installation
Install the optional UT-109 or UT-110 unit as follows:
q Turn the power OFF, then disconnect the DC power cable.
w Unscrew the 4 cover screws, then remove the bottom
cover.
e Cut the pattern on the PCB at the TX mic circuit (MIC) and RX
AF circuit (AF OUT), then solder CP37 as shown below.
MIC and AF OUT
FRONT FRONT
CP37
☞ Continued on the next page.
4
4
27