Icom IC-F1710 Instruction Manual page 21

ï Direct code entry
q While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Code digit for editing blinks.
0 5 0 0
w Push [P3] (TX Code Enter) to select the desired digit to
be edited.
• Digit for editing differs according to the setting.
e Set the desired digit using [CH Up]/[CH Down]/[DIAL] or
10-keypad*.
*IC-F1810 or IC-F2810 only
r Push [P3] (TX Code Enter) to set the digit, then the digit to
the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver
repeats the call 3 times (default) automatically, and
is displayed during each call. However, an error beep
sounds and "FAILED" is displayed when no answer back
is received after the calls.
u Push [PTT] to transmit; release to receive.
i Push [P4] (Moni(Audi)) to send the 'Clear down' signal.
For your information
When the "UpDate" setting for the call code is enabled, the set
code is overwritten into the call code memory.
" "
WAIT
3
BIIS OPERATION
3
17