Resetting; Partial Reset - Icom ID-51A Basic Instructions

14

RESETTING

■ Resetting
The display may occasionally display erroneous information
(for example when first applying power). This may be caused
externally by static electricity or by other factors.
If this problem occurs, turn OFF power.
After waiting a few seconds, turn ON power again. If the prob-
lem persists, perform a Partial reset or an All reset.
A Partial reset resets operating settings to their default values
(VFO frequency, VFO settings, menu contents) without clear-
ing the items below:
• Memory channel contents
• Call channel contents
• Message data
• GPS Memory contents
• BC Radio Memory
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. See the PDF
type Advanced Instruction for more details.
49
• Scan Edge contents
• Call sign memories
• DTMF memory contents
• Repeater list
D Partial reset
q Push [MENU] to enter
the Menu screen.
Push D-pad( ) to select the
w
root item (Others), and then
push D-pad(Ent) to go to the
next level.
D-pad
(Ent)
(�)
( MENU > Others > Reset >

Partial Reset)

Refer to the menu sequence
e
shown directly above and
push D-pad() to select, and
then push D-pad(Ent) to en-
ter, one or more times until
the last screen is displayed.
Go to step r