Gps Operation; Step1 Receiving Gps Data From The Internal Gps Receiver - Icom ID-51A Basic Instructions

11

GPS OPERATION

The ID-51A/E has a built-in internal GPS receiver. You can
check your current position, or transmit GPS data in the DV
mode.
Receiving GPS data from the internal
STEP 1
GPS receiver
q Push [MENU]
the Menu screen.
Push D-pad( ) to select the
w
root item (GPS), and then
push D-pad(Ent) to go to the
next level.
D-pad
(Ent)
(�)
( MENU > GPS > GPS Set>
GPS Select)
Refer to the menu sequence
e
shown directly above and
push D-pad() to select, and
then push D-pad(Ent) to en-
ter, one or more times until
the last screen is displayed.
43
to enter
Go to step r
See the PDF type Advanced Instruction for more details of
the GPS operation.
Push D-pad( ) to select "In-
r
ternal GPS."
t Push [MENU] to exit the
Menu screen.
• The GPS icon blinks when re-
ceiving data, as illustrated be-
low, and stops blinking when
valid data is received.
➝ ➝ ➝
- If "Manual" was selected, the
icon does not appear.
• It may take only a few seconds
to receive, but depending on the
environment, it may take a few
minutes. If you have difficulties
receiving, we recommend that
you try a different location.
GPS Select screen
Blinks