Gps Logger Function; Step1 Receiving Gps Data From The Internal Gps Receiver - Icom ID-51A Basic Instructions

12

GPS LOGGER FUNCTION

The GPS Logger function allows you to store the GPS position
data (Latitude, Longitude, Altitude, Positioning state, Course,
Speed and Date) onto a microSD card, as your route.
If you use this function while driving, you can check your driv-
ing course on a mapping software.
Receiving GPS data from the internal
STEP 1
GPS receiver
q Push [MENU]
the Menu screen.
Push D-pad( ) to select the
w
root item (GPS), and then
push D-pad(Ent) to go to the
next level.
D-pad
(Ent)
(�)
( MENU > GPS > GPS Set>
GPS Select)
Refer to the menu sequence
e
shown directly above and
push D-pad() to select, and
then push D-pad(Ent) to en-
ter, one or more times until
the last screen is displayed.
45
to enter
Go to step r
NOTE:
The GPS logger function requires a microSD card.
• See p. 39 for more details.
Push D-pad( ) to select "In-
r
ternal GPS."
t Push [MENU] to exit the
Menu screen.
• The GPS icon blinks when re-
ceiving data, as illustrated be-
low, and stops blinking when
valid data is received.
➝ ➝ ➝
- If "Manual" is selected, the icon
does not appear.
• It may take only a few seconds
to receive, but depending on the
environment, it may take a few
minutes. If you have difficulties
receiving, we recommend that
you try a different location.
Blinks