Alter Parameters For All File Types - HP T6553 D45 Reference Manual

FUP Commands
For files with alternate-key fields:
ALTFILE ( key-file-number , filename )
ALTKEY ( key-specifier { , altkey-param }... )
DELALTFILE key-file-number
DELALTKEY key-specifier
For partitioned files:
PART ( sec-partition-num ,
[ \node.]$volume
[ , pri-extent-size [ , sec-extent-size ]] )
PARTONLY
For unstructured files:
BUFFERSIZE unstructured-buffer-size
ODDUNSTR

ALTER Parameters for All File Types

These alter-option parameters are available for all file types:
[ NO ] AUDIT
designates the file as audited or nonaudited by TMF. If you specify AUDIT, FUP
marks the file as an audited file. If you specify NO AUDIT, FUP marks the file as a
nonaudited file. To use the AUDIT option, you must have read and write access to
a file (or be the super ID 255,255).
Note. For more information, see the TMF Planning and Configuration Guide.
[ NO ] AUDITCOMPRESS
sets the mode of producing audit-checkpoint messages (using compressed or
entire messages) for audited files. The default is NO AUDITCOMPRESS.
[ NO ] BUFFERED
sets the mode of handling write requests to the file using buffered or write-through
cache. BUFFERED specifies a buffered cache. NO BUFFERED specifies a write-
through cache. The default is BUFFERED for audited files and NO BUFFERED for
nonaudited files.
Caution. If you use the buffered-cache option on a DP2 file that TMF does not audit, a system
failure or disk-process takeover can cause the loss of buffered updates to the file. An
application might not detect this loss, or handle the loss correctly unless it is modified to do so.
File Utility Program (FUP) Reference Manual—523323-014
ALTER Parameters for All File Types
2-10