HP T6553 D45 Reference Manual page 260

FUP Messages
Recovery. Retry the LISTLOCKS operation.
DRIVE DOES NOT SUPPORT TAPEMODE SELECTION
Cause. The TAPEMODE parameter was used for a tape drive that does not support
the setting.
Effect. The COPY or BUILDKEYRECORDS command continues without trying to set
the tape mode.
Recovery. Informational message only; no corrective action is needed.
DRIVE DOES NOT SUPPORT THIS DENSITY SELECTION OR CAN ONLY
CHANGE DENSITY AT BOT
Cause. A DENSITYOUT parameter was specified for a tape drive that does not
support density selection, or the DENSITYOUT parameter was specified when the tape
was not at the beginning.
Effect. The COPY or BUILDKEYRECORDS command continues without trying to set
the density.
Recovery. Informational message only; no corrective action is needed if the tape drive
was at the correct density.
DUPLICATE SECONDARY PARTITION VOLUME NAME
Cause. The same volume was specified for more than one partition of a partitioned
file.
Effect. The CREATE, ALTER, or DUP command fails.
Recovery. Each partition of a partitioned file must reside on a separate disk volume.
EDITREAD ERROR
Cause. An error occurred while the system was reading an EDIT file (READEDIT); it
was probably a file-format error.
Effect. The command fails.
Recovery. For corrective action, see the Guardian Procedure Errors and Messages
Manual.
source-file :
Cause. A file contained empty records.
EMPTY RECORD FOUND AND NOT TRANSFERRED
File Utility Program (FUP) Reference Manual—523323-014
3-8